CAUTION
Inlet and discharge interconnecting lines should be constructed of a
NON-FERROUS material. Examples of some suitable materials are PVC,
copper-nickel, 316 stainless steel pipe or a reinforced non-collapsing
hose. Ferrous piping produces rust that will irreversibly foul the membrane
and void the RO unit warranty.
NOTE
Avoid connecting the inlet piping to any water line that services any
other piece of equipment. Air could be drawn through the RO unit
causing damage to the RO unit's pumps.
CAUTION
The use of galvanized steel for product piping should be avoided as small
amounts of rust may form that can be drawn back into the RO when the
system is off.
Exposing the membranes to chlorinated water may cause irreversible
damage and will void the RO unit warranty, so use the carbon flush filter
supplied.
NOTE
Strictly observe all applicable electrical codes and regulations governing
the installation and wiring of electrical equipment. Typical codes specify
the type and size of conduit, wire diameter and class of wire insulation
depending upon the amperage and environment. The power supply
should always be of a greater service rating than the requirements of the
RO unit. This will assure proper voltage even if power supply voltage is
slightly less than required. Never connect the RO unit to a line that
services another electrical device. The RO unit should have its own
dedicated power supply and breaker.
WARNING
Disconnect electrical power to RO unit and the power source before
connecting to RO unit interface. Failure to do so can cause serious injury or
death to personnel.
a) Connect the correct voltage/power supply 115/220VAC, 1 PHASE, 60/50 Hz to the
power box. Refer to the name plate for proper voltage.
b) Connect a suitable ground to the RO unit skid (as determined by the specifics
of your installation).
Содержание Sea Recovery ULTROClear Series
Страница 2: ...Intentionally left blank ...
Страница 18: ...Figure 3 4 Major Components Location ...
Страница 31: ...8 0 SYSTEM DRAWINGS AND DIAGRAMS AND PARTS LIST ...