Chapter 2: Installing the Monitor
Mounting the Monitor in an Enclosure
PHM/PM User Guide
2-6
To mount the adapter on the back of the monitor:
1
Place the monitor face-down on a static dissipative mat in a location
free from dirt and moisture and protected against static discharge.
2
Place the external AC adapter between the four mounting holes in the
center.
Make sure that the adapter’s DC connection is toward the top of the
monitor and that the AC connection is toward the bottom.
3
Place the two adapter mounting clamps over the top and bottom of
the adapter. Align the holes in the clamps with the mounting holes in
the back of the monitor.
Notice that the lower mounting clamp has a special extension that
reaches down over the AC connection and holds it in place.
4
Fasten the adapter to the monitor with the four retaining screws
included in the adapter installation kit.
For instructions on how to mount the external AC adapter near the
monitor, see the documentation that accompanies the adapter installation
kit.
Preparing the Power Connector
Prepare the power source for the unit by sliding the positive and negative
wires into the appropriate slots on the power connector as shown in Figure
2-2 Power Connector.
Figure 2-2: Power Connector
Connect the ground cable from the power connector to an earth ground.
