Parker IM20 Series, Руководство по эксплуатации продукта

Страница: 29 / 74

5.5 Panel Display
Items and Remarks Displayed on the Panel
Items Remarks
-HF- It indicates servo drive is resetting.
OC, OE, OL1, OL2,
OH, ESP, ESP1, LU,
PF1,
PP-1, PP-2,
PGo, Tro, AL05,
AL14, ERR2, ERR3
Fault code, indicating “over-current ”, “over-voltage”, “servo drive over-load”,
“motor over-load”, “servo drive over-heat”, "motor over-heat", “Emergency
stop”, “under-voltage protection”, “out-phase for input”, “pressure sensor
fault”, “Pump reversal running fault”, “Resolver fault”, “KTY84
disconnected”, “Resolver pole position fault”, “Braking unit fault”,
“identification
of motor parameter fault”,
“over-current
before
running”respectively.
H.H.
Interruption code, indicating “external interruption” signal input and showing
“0” after reset.
TEST Motor pole position study.
F100 Function code (parameter code).
10.00 Indicating servo drive running frequency and parameter setting values, etc.
1800 Indicating speed of servo motor
Will flash in Stop condition to display target frequency.
A100
、
U100
Output current (100A) and output voltage (100V). Keep one digit of decimal
when current is below 100A.
u540 DC bus voltage between P- (540V)
H26 The temperature internal servo drive is 26
℃
h26 The temperature internal servo motor is 26
℃
P140 Control board set pressure (bar)
P. 140 Feedback value of pressure sensor. (bar)