Parker IM20 Series, Руководство по эксплуатации продукта

Страница: 27 / 74

27
V. Keypad panel
5.1 Panel Illustration
The panel covers three sections: data display section, status indicating section and keypad operating section, as shown in Fig.
5-1.
M
E
▲
▼
I
O
RUN FWD DGT FRQ
5.2 Panel Operation
All keys on the panel are available for user. Refer to Table 5-1 for their functions.
Table 5-1 Uses of Keys
Keys
按
键
Names Remarks
Fun To call function code and switch over display mode.
Set To call and save data.
Up To increase data (speed control or setting parameters)
Down To decrease data (speed control or setting parameters)
Run
To start servo drive;
Stop or reset
To stop servo drive; to reset in fault status; to change function codes in a
code group or between two code groups.
5.3 Parameters Setting
Table 5-2 Steps for Parameters Setting
Steps Keys Operation Display
1
Press “M” key to display function code
2
Press “Up” or “Down” to select required function code
3
To read data set in the function code
4
To modify data
5
To display the current function code
The above-mentioned step should be operated when servo drive is in stop status.
5.4 Function Codes Switchover in/between Code-Groups
Press “M” key so that the keypad controller will display function code. If press “▲” or “▼” key then,
function code will circularly keep increasing or decreasing by degrees within the group; if press the “O” key
again, function code will toggle between two code groups when operating the “▲” or “▼” key.
e.g. when function code shows F111 and DGT indicators on, press “▲”/ “▼” key, function code will keep
▲
▼
or
E
E
▲
▼
or
F
1
1
4
F
1
1
4
M
M
E
I
O
▲
▼
Operation
panel
LED shows running frequency, flashing target frequency,
function code, parameter value or fault code.
4 LEDs indicate working status. RUN is lighting while running. FWD is
lighting when working forward and FRQ is lighting when showing
frequency.
Press “M” for function code, and “E” for original parameters.
▲
and
▼
keys can be used to select function codes and parameters.
Press “E” again to confirm. In the mode of keypad control,
▲
and
▼
keys can also be used for dynamic speed control. “I” and
“O” keys control start and stop. Press “O” key to reset servo
drive in fault status.