Parallax ELEV-8 V2, Инструкция по сборке

Страница: 108 / 130

Step 32: Connect Receiver Signal Cables
Important!
​
If you have the ELEV-8 V2 No Flight Controller kit (#80202): the directions in
Section 7 are specifically meant for installing and connecting the HoverFly OPEN control board
only ​ . Use caution if attempting to adapt some or all of these directions for any other control
board. Parallax accepts no liability for the use of these directions with components not sold or
provided by Parallax for your specific kit.
In this step you will connect the Signal Cables for the receiver to both the HoverflyOPEN Flight
Controller and the Receiver.
Tools Needed
● Sharp Knife, Razor Blade, or Sandpaper (between 80 and 200 grit)
Parts Needed
● 1 – RC Radio Receiver (Images provided are of Orange RX receiver; your receiver may
differ)
● 5 – Servo Cable, 8" (#800-00080)
● ELEV-8 Assembly, prepared in Step 31
Instructions
1. Take your receiver and determine the correct orientation to plug the cables into the unit.
Many receivers have some sort of symbol such as “^ + –” to indicate orientation, where
^ corresponds to the white signal wire, + corresponds to the red positive wire, and -
corresponds to the black negative wire. On most Spektrum, Orange RX, and Futaba
Receivers, the white signal wires are on “top” as is the case in the image below.
Copyright © Parallax Inc. ELEV-8 V2 Assembly Guide
07/26/2018