Parallax ELEV-8 V2, Инструкция по сборке

Страница: 73 / 130

Step 22: Configure the Transmitter and Bind to Receiver
Radio transmitters come with an overwhelming array of settings. This step will guide you
through configuring your transmitter so that it can properly control your ELEV-8. Below is a table
of transmitter setting recommendations for flying the ELEV-8, regardless of transmitter selection.
You will also “bind” your transmitter to your receiver, which enables your particular transmitter to
control your particular receiver for the ELEV-8.
Parts Needed
● RC Radio Transmitter and Receiver (w/ Bind Plug)
● ELEV-8 assembly, prepared in Step 21
● LiPo Battery, prepared in Step 5
Transmitter Settings
Box Model Type ACRO (Plane Mode)
End Point (Travel)
Adjustment
Set aileron and elevator to 50% initially. If the ELEV-8 still seems
too reactive, reduce to 30% until you get used to flying it
Dual-Rates (D/R) 100%
Channel Reverse Normal for the following brands: HiTec, Spektrum, JR.
Reverse for the following brands: Futaba
Trims Centered
Sub-Trims Centered
Gain Adjustment Set gain on 5th channel. Start with 25%, add or subtract based on
flying stability
Exponential After gaining experience, add up to 30% into aileron and elevator
Configuration Instructions
We’ll guide you through making these settings on a Spektrum DX6i, DX7, and DX8, and ORX
T-SIX transmitter in the following instructions. To get started, choose the your transmitter type
from the list below. Once you have finished configuring your transmitter, scroll down the page to
find the receiver binding instructions.
● Spektrum DX6i
● Spektrum DX7
Copyright © Parallax Inc. ELEV-8 V2 Assembly Guide
07/26/2018