Paradyne JetFusion 2004, Руководство пользователя

Страница: 41 / 216

A d m i n i s t r a t i o n 3-9
2
Type the IP address and press Enter. The IAD saves the configuration.
3
Continue with other SNMP settings, or press Escape to return to the Main
menu.
4
Reset the IAD.
Enable/Disable SNMP Traps via EOC
To Enable or Disable SNMP Traps via EOC, follow the steps below.
1
Type
“U”
on the SNMP Configuration menu to enable or disable SNMP
traps via EOC. The IAD displays the current status.
2
To enable traps via EOC, type
E
. To disable them, type
D
. The IAD saves
the configuration.
3
Continue with other SNMP settings, or press Escape to return to the Main
menu.
4
Reset the IAD.
Configure Restart Trap Maximum Delay
To configure Restart Trap Maximum Delay, follow the steps below.
1
Type
“D”
on the SNMP Configuration menu to configure the restart trap
maximum delay time. The IAD prompts you to input a new value.
2
Type the new value in seconds and press Enter. The IAD saves the
configuration.
3
Continue with other SNMP settings, or press Escape to return to the Main
menu.
4
Reset the IAD.
Defining Different SNMP Version 3 Categories
SNMP is supported via Internet Protocol (IP) and the Loop Emulation System
Embedded Operation Channel (LESEOC). The LESEOC interface is only
available with either the AAL2/LES CAS or ELCP voice gateway. This
interface allows the voice gateway to monitor and control specific JetFusion
IAD operational parameters.
NOTICE:
Some voice gateways with this feature require a read-write community
name of LESEOC to be configured in the IAD.
The SNMP Configuration menu is accessible from the Main menu. You may
enable SNMP via IP, EOC, or both. Traps may be sent to a configurable IP
address, the EOC, or both. The System Contact, System Name, and System
Location may also be configured. These values are accessible via the RFC
1213 MIB.