Paradyne JetFusion 2004, Руководство пользователя

Страница: 159 / 216

R e p o r t s 5-27
You must enable bridging for this information to display. For more
information on enabling bridging, refer to
Bridge Configuration on page 4-27.
Bridge Status Report
To display information about bridging, type
“S”
on the Reports Menu. The
IAD displays a record for each interface as shown in the table below.
The spanning state timer value is for listening or learning states and counts
down from the forward delay time to zero.
The hello timer value is valid only if the active port is the Root Bridge of the
network. It counts down from the hello time to zero.
•
Root priority
−
priority of the root bridge on the network.
•
ID
−
Ethernet MAC address of the root bridge on the network.
Press any key to return to the Reports menu.
PPP Authorization Entries Report
Type
“P”
on the Reports menu to display information about PPP
authorization entries. If no PPP authorization entries have been created, the
IAD displays a message to confirm this.
Port Port for the Ethernet interface
Timer No. of seconds until this entry deletes from the
database. The time counts down from the bridge
database aging time value, in one-second intervals; at
zero, the entry deletes from the database.
Parameter Description
Parameter Description
Interface interface for the active slot for bridging
Port port for the preceding interface
Spanning Tree Protocol (STP) enabled | disabled
State Spanning tree state: disabled | blocking | listening
|learning | forwarding
Root root port for the bridge—yes | no
Designated designated port for the bridge—yes | no
Timers current values of the spanning state timer (first
value) and the hello timer (second value)