3
Section 1:
Installation Consideration
The placement of the individual
components of the Marine Magellan system
is very important. The installer must make
sure that adequate security concerns and
end user
“
ease of use
”
are taken into
account. Reference the following guidelines
before drilling any holes or running any
wires.
Supply Voltage
The Marine Magellan wireless security
and monitoring system must be installed in
an adequate and well thought out location
on your vessel. The system can be
powered from the vessels 110 AC (VAC)
supply and stepped down through our 16
VAC transformers. It can also be powered
by the vessels domestic battery banks 12
volts DC (VDC). It is important to establish
what voltage supply best suits your vessels
needs. Typically an AC power source is
used on all vessels that have a constant AC
source from shore power or a generator.
Powering the system through the vessels
battery banks is typically done on smaller
boats where AC power is not constant
Wire needs
-18 AWG / 2 conductor wire
Approximately 20 ft.
- Communication wire / 2 conductors
Telephone wire, Cat 5, or similar
approximately 12 ft.
AC installation
There must be a constant 110 VAC
source in the vicinity of the units for power.
The 16 VAC transformer must plug into the
110 VAC outlet. It is suggested that an
isolated outlet be installed strictly for the
plug in transformer(s). The 16 VAC output
feeds to the Marine Magellan head unit and
another transformer can feed to the Artion
Battery backup board. The Artion Battery
backup converts this 16 VAC to 12 VDC
while charging the battery backup for the
Artion. It is important that this AC source be
constantly powered when the boat is not
being used. It is suggested that you power
the system off of its own breaker.
DC installation
There must be a constant 12 Volt DC
(Direct Current) source in the vicinity of the
units for power. This 12 VDC must feed the
Marine Magellan and the Artion GSM
module directly. On DC installations the
Artion battery backup is not used.
Location Considerations
The Marine Magellan and the Artion
GSM Module must be mounted on the
interior of vessel. They should be
located as centrally as possible to all the
proposed zones. This area must be
clear from moisture and not susceptible
to drastic temperature changes.
Содержание Marine Magel 6130
