Paradox Marine Magel 6130, Инструкция по установке

Страница: 21 / 44

21
Diagram 15
Mounting
It is suggested that you first apply the
door contact and magnet with double sided
tape and test it before permanently
mounting the unit. Once you have mounted
it and put your batteries in, programmed and
tested for operation, you then can then pre-
drill and screw in you door contacts.
Jumpers
You will notice a jumper at
“ JP1 ” . With
the jumper
“ on ” the contact will reed open to
the Marine Magellan panel when the magnet
is not present. With the jumper
“ off ” the
contact will reed closed to the Marine
Magellan panel when the magnet is not
present (Table 1). This comes in handy with
specific sensing applications that may have
opposite normal states.
Table 1
Learn Mode
Learn Mode allows you to transmit the
serial numbers of each input to your Marine
Magellan console wirelessly. To enter Learn
Mode, open the cover and wait until the LED
stops flashing. There are two methods to
program the DCTXP2 depending on whether
the
“ Magnet Reed Switch ” or
the
“ Universal
Transmitter Input
” is being utilized (Table 2
).
Make sure that the Marine Magellan is in the
proper programming screen and says
“ Press
Tamper or Press Learn Btn
”
(6
–
Zone
Profile, Programming). Essentially, if you
are using the
“ Magnet R
eed switch
” ,
momentarily
press the red tamper switch once in one
second. If you are programming
the
“ Universal Transmitter Input ” , simply
momentarily press the red tamper button
twice in one second.
Jumpers
JP1 ON
Normally Open
Reed Switch/Universal Input:
open =
“ zone open ” signal
closed =
“ zone closed ” signal
JP1 OFF
Normally Closed
Reed Switch/Universal Input:
open =
“ zone closed ” signal
closed =
“ zone open ” s
ignal
JP2 Not Used