Paradox Marine Magel 6130, Инструкция по установке

Страница: 25 / 44

25
Diagram 20
High Water Alarm
Typical Position: Bilge Areas
Typical Zone Definition: 24 Hour Buzzer
Power: 2 x
“ AAA ”
Description: The High Water detector is
designed to monitor the water level in your
bilge. The High water float switch is
mounted on the stringers in various areas of
your bilge. The switch is wired to the
DCTXP2 wireless sensor located in a
sealed, waterproof, plastic enclosure
(Diagram 20). Unscrew the four screws
holding the cover and open it up. Inside you
will see a DCTXP2. Power the DCTXP2
and then program the DCTXP2 to a zone
location of the Marine Magellan (see
DCTXP2,
“ Universal Transmitter Input ” )
Mounting
Now you must mount the plastic high water
alarm and 90 degree plastic shelf in the
bilge. Typically the switch is mounted 6 to 8
inches from the bilge bottom. The best
reference to mount it is about a half inch
below the level of the boat manufacturers
existing high water switch. The sealed
plastic box housing the DCTXP2 should be
mounted above the float switch.
6 - Zone Profile Programming
You should now have a general
understanding of using the wireless sensors
and the definitions associated with them. It
is now time to program these sensors
individually to each zone location of the
Marine Magellan console. For
organizational sake, it is suggested that you
keep like sensors grouped together. For
example, if you have five different door
contact zones and two High water zones,
allocate the doors to zones 1 -5 and the
High Waters to zone 6 and 7. This action