Paradox Marine Magel 6130, Инструкция по установке, Страница: 23 / 44

23
into position. This will activate the motion
detector
’ s walk
-test mode for 3 minutes.
Learn Mode
Power up the unit and allow the LED to
cycle out with the cover open. Make sure
that the Marine Magellan is in the proper
programming screen and says
“ Press
Tamper or Press Learn Btn
”
(6
–
Zone
Profile, Programming). Press the tamper
switch on the board once briefly (Diagram
17 reference
“ B ” ).
SD-738 Smoke Detector
Typical Position: Galleys, salons, and
electrical closets
Typical Zone Definition: Delay Fire
Power: 9V Battery
Description: This device has a high-
sensitivity photoelectric smoke sensor with
its own built-in siren (Diagram 17).
Diagram 17
Powering the Unit
Open up the back cover of the unit to access
the 9 volt battery. There is a plastic wrap
around the battery that needs to be
removed. Snap in the battery, place it in the
compartment, close the cover, and secure it
with the included screw.
Replacing the Batteries
When the Battery starts to fade out, the
device will generate an alarm every 15
minutes to alert you of it.
Mounting
Place the mounting plate in the designated
location. Pre-drill and secure the plate.
Place the detector onto the plate, match up
the key, and turn clockwise until it stops.
Learn Mode
With the unit powered up, make sure that
the Marine Magellan is in the proper
programming screen and says
“ Press
Tamper or Press Learn Btn
”
(6
–
Zone
Profile), Programming). Hold down the test
button on the top of the smoke detector for
approximately three seconds.
Battery Low Voltage Detector
Typical Position: Domestic battery Banks
Typical Zone Definition: 24Hour/Buzzer
Power: 2 x
“ AAA ”
Description: The Battery Low Voltage
detector is designed to monitor vessels
battery bank(s) for low voltage. The voltage
detector opens the zone when the battery
voltage drops below 11.6 for a 12 VDC bank
or 23.2 for a 24 VDC bank for a period of