Paradise Datacom 4 RU Chassis, Руководство по эксплуатации

Страница: 29 / 130

4 RU SSPA Chassis Operations Manual 201627 REV X 29
2.2.1.7 Sys Info Page 7
This page shows RF module related faults and conditions.
•
Regulator - RF module regulator low voltage fault. Values - "Fault" or
"Normal";
•
DC Current - low DC current fault. Values -"Fault" or "Normal";
•
Temperature - high temperature fault. Values - "Fault" or "Normal";
•
Temp.(C) - internal RF module plate temperature in Celsius.
2.2.1.8 Sys Info Page 8
This page shows individual RF module states in multi-module HPA.
If a particular module does not exist in the HPA configuration, the value shows
"N/A" (not available). Each value represents summary fault state of the individual RF
module, which includes Voltage, Current and Temperature state as well as quality of
data connection with module.
If the HPA controller card can not reliably communicate with an SSPA module; that
module will be declared faulted. This type of fault will not affect HPA overall summary
fault state, because the controller card has the ability to track RF module faults
independently.
2.2.1.9 IP Info Page1
This page is available through the Comm. Setup menu, and shows SSPA settings
related to the IP interface.
•
IP Address – IP address of the SSPA. Consult your network administrator to
set this address according to your LAN configuration.
•
MAC – Medium Access Control address of the SSPA Ethernet controller.
This address is factory preset.
•
Subnet – IP subnet mask of the SSPA. Consult your network administrator to
set this address.
•
IPPort – IP port value for the SSPA. This address is valid only when IPNet
protocol is selected. The port value should not be selected outside the
existing services range to avoid access conflict on the M&C PC end.
2.2.1.10 IP Info Page 2
This page shows SSPA settings related to the IP interface.
•
Gateway – IP Gateway address. This address is used only if access to the
SSPA is provided from an outside LAN. If no such access is required, the
address must be set to 0.0.0.0