Paradise Datacom 4 RU Chassis, Руководство по эксплуатации

Страница: 101 / 130

4 RU SSPA Chassis Operations Manual 201627 REV X 101
To do so on a Windows based PC, open a Command Prompt window and type PING
and the dot delimited IP address of the RM SSPA, then press the Enter key. If the unit
is successfully found on the network, the request statistic will be displayed.
PING
XXX.XXX.XXX.XXX
If the unit does not answer on the ping command, check all hardware connections and
verify that the IP settings on your host workstation and the RM SSPA match your net-
work parameters. On a Windows based PC you may also check ARP table entries.
The new IP address of the RM SSPA may be set to another PC or network equipment
with a different MAC address. Open a Command Prompt window and type "ARP -a”,
the press Enter. The current table will be displayed. If you see the RM SSPA IP
address entry in the table, delete it by issuing the command "ARP -d
XXX.XXX.XXX.XXX” and press Enter (XXX.XXX.XXX.XXX is the IP address of the RM
SSPA unit). Now try the PING command again. More information about how to set up a
network connection with the RM SSPA can be found in
Appendix B
.
7.6.1.3 Using the Rack Mount Web Interface
With the Ethernet Interface activated as described in
Section 7.6.1.2
and an IP
Address assigned to the unit, launch a Java- (version 1.5 or higher) and Javascript-
enabled web browser (such as Internet Explorer, Firefox, or Opera.
Enter the SSPA’s IP address into the Address Bar of your web browser, and the
interface screen will load in the browser window, as shown in
Figure 7-11
.
Figure 7-11: Web Interface Status Window