Panduit Synapsense, Руководство по установке

Страница: 22 / 33

INTELLIGENT GATEWAY INSTALLATION MANUAL
21
4. Connect the designated Ethernet Cable (originating from a server port assigned by the data center's
IT department) to the Gateway.
5. The Radio Activity LED will remain ON to indicate on-going radio communication activity.
6. The Unit Status LED will remain OFF unless there is a problem. See Troubleshooting for a table of
status colors. Secure and route Power Adapter wire and Ethernet Cable using adhesive Cable Clips.
7. Repeat previous steps for remaining Gateways to be installed.
When all Gateways are installed, proceed to the Final Installation Activities section.
3M Command Strip
Adhesive mounting is used for solid surfaces where a mounting shelf cannot be used.
To mount a gateway with command strips
1. Clean installation surface with alcohol wipes. Allow area to dry thoroughly.
2. Attach Command Strips (double-sided adhesive strips) to the back of the Gateway to anchor it to the
rack.
3. Connect the Power Adapter to the Gateway and the designated power outlet.
4. Connect the designated Ethernet Cable (originating from a server port assigned by the data center's
IT department) to the Gateway.
5. The Radio Activity LED will remain ON to indicate on-going radio communication activity.
6. The Unit Status LED will remain OFF unless there is a problem. See Troubleshooting for a table of
status colors.
7. Remove adhesive covers from the Command Strips on the back of the Gateway.
8. Mount the Gateway onto cleaned surface (i.e., top of server cabinet). Press firmly for 30 seconds .
9. Secure and route Power Adapter wire and Ethernet Cable using adhesive Cable Clips.
10. Repeat previous steps for remaining Gateways to be installed.