Panasonic WJSX150 - SWITCHER - ADDENDUM, Руководство по эксплуатации

Страница: 43 / 148

■
Connection with Digital Disk Recorder WJ-HD100 Series
1. To record the camera images with Digital Disk Recorder WJ-HD100 Series, install an optional Multiplexer board in the
matrix switcher.
2. Connect the matrix switcher’s EXT OUT (REC OUT) to the digital disk recorder’s VIDEO IN with a coaxial cable.
3. Connect the matrix switcher’s EXT IN (PLAY IN) to the digital disk recorder’s MONITOR OUT (PLAY) with a coaxial cable.
4. Connect the matrix switcher’s DATA HDR to the digital disk recorder’s DATA with a modular cable.
5. Connect the matrix switcher’s CAMERA SW IN to the digital disk recorder’s CAMERA SW OUT with an RCA-pin cable.
6. Select “HD100” for 610 RECORDER CONTROL in SETUP MENU. (Refer to p. 60.)
7. Conform the parameter of 740 PSD PORT SPEED to the setting of the recorder.
The following parameters are fixed.
Data bit: 8 bits
Parity check: None
Stop bit: 1 bit
8 Conform the parameter of 620 RECORDER UNIT ADDRESS in SETUP MENU to the setting of the recorder. (Refer to the
recorder’s operating instructions for the unit address.)
Note: After the connection, configure the system through SETUP MENU and WJ-SX150 Administrator Console.
●
DATA HDR Port
44
WJ-HD100 series Digital Disk Recorder
SIGNAL GND
ALARM SERIES
RECORD
TIME
ADJUST
REMOTE
MODE DATA RS-232C VIDEO
OUT
IN
OUT
IN
AUDIO MONITOR OUT
(PLAY)
CAMERA
SW OUT
G G G
POWER
ON
OFF
JOG-CLICK JOG-LEFT JOG-RIGHT ALARM SEARCH STEP REW/FF STOP/SETUP PLAY REC OUT PLAY OUT REC OUT AUTO OFF OUT DISK END OUT IN OUT IN RECALL (EXT REC) OUT RECOVER OUT RESET IN IN
WJ-SX150 MatrixSwitcher
Pin #10 (Alarm Out 1)
Pin #11 (Alarm Out 3)
2
DATA 3 DATA 2
SERIAL ALARM
TERM
OFF ON
4
2
1
4
3
CAMERA
SW IN
RS485(CAMERA)
LINE
SELECT
MONITOR OUT
EXT IN
(PLAY IN)
EXT OUT
(REC OUT)
RS485(CAMERA)
DATA 4 DATA HDR
PS•DATA
DATA 1
Pin #24 (Alarm Out 4)
Pin #13
(Recover Input)
Pin #23 (Alarm Out 2)
Pin #9 (GND)
TB
TA
RB
RA
GND
GND
Matrix switcher's rear panel
DATA HDR
TB
TA
RB
RA
DATA HDR Port