Panasonic WJHD309 - DIGITAL DISK RECORDER, Руководство по эксплуатации

Страница: 102 / 164

102
x
Move the cross cursor onto an area to be deleted using
the arrows button and press the SET button.
c
To complete the settings, rotate the jog dial to select
"EXIT" on the status bar.
→
The "VMD Setup" window will be closed.
8 Set the sensitivity
Set the sensitivity for the created motion detection area.
Sensitivity can be set for each area.
[Screenshot 1]
Start operation from the "VMD Setup" window.
z
Rotate the jog dial to select "SENSITIVITY" on the status
bar.
[Screenshot 2]
The sensitivity of the selected detection area will be dis-
played.
x
Move the cross cursor to select an area using the
arrows button (
A B
).
c
Select the sensitivity for the selected area from the fol-
lowing.
OFF: No motion will be detected in this area.
LOW: Low sensitivity
MID: Standard sensitivity
HIGH: High sensitivity
v
To complete the settings, rotate the jog dial to select
"EXIT" on the status bar, and press the SET button.
→
The "VMD Setup" window will be closed.
8
Set the detection mode
Perform the settings of the detection mode (method of
detection) in the set detection area. Specifying a method of
detection in a detection area is available by setting the
detection mode.
[Screenshot 1]
Start operation from the "VMD Setup" window.
z
Rotate the jog dial to select "VMD MODE" on the status
bar.
[Screenshot 2]
The detection mode menu will be displayed.
x
Set the detection mode.
Move the cursor to the desired detection mode using
the arrows button (
A B
).
Move the cursor on the desired detection mode using
the arrows button (
A B
) and check the radio button
next to the selected mode using the arrows button (
C
D
).
Refer to the following for further information about each
of the detection modes.
<ANY AREA>
An event action will be performed according to the set-
tings when "motion" is detected in any of the set motion
detection areas.
<VECTOR>
Move the cursor to an area for the settings of VECTOR
using the arrows button (
B
) and select an area using
the arrows button (
C D
). Move the cursor to the para-
meter box of the selected area using the arrows button
(
B
), and then press the arrows button (
C D
) to select
an interval time for an object moving between each
area from the following.
--/5 s/10 s/20 s/30 s/40 s/50 s/1 m(min)