-17-
■
Connection with the Monitors
Connect the Monitors to the Spot Output (SPOT
OUT) Connector and Multiscreen (MULTISCREEN)
Connector on the rear of the Video Multiplexer.
■
Connection with the WV-CU550A System
Controller
If the supplied 6-conductor cable assembly is
used, simply plug one end of the cable into the
DATA IN port of the Video Multiplexer and the other
end into DATA OUT port on the System Controller.
If you use cables assembled from locally procured
materials, it is important that only high quality, data
grade cable, suitable for RS-485 “2-wire twisted
pair shielded cable” is used.
Low grade cable will result in unstable operation of
the system.
●
Setting the Termination and Controller Unit
Number
The Termination Switch and the Controller Unit
Number Switch are located on the rear of the
System Controller.
When combined with the WJ-FS616 Video
Multiplexer, always keep these switches in the
positions shown below.
●
Setting the Mode Selection Switch
The Mode Selection Switch, that selects the opera-
tion mode of the System Controller, is located on
the rear of the System Controller.
When combined with the WJ-FS616 Video
Multiplexer, always keep these switches in the
positions shown below.
SPOT
MULTISCREEN
OUT
I N
S–VIDEO
VIDEO
Video Multiplexer
WJ-FS616
TERM.
MODE
ON
OFF
0
OFF
ON
TERM.
OFF
IN
OUT
ON
DATA
IN
OUT
TERM
ON
OFF
DATA
0 1
2
3
45
6
7
8
9
CONTROLLER
UNIT NO.
1-8
Video Multiplexer
WJ-FS616
System Controller
WV-CU550A
