Panasonic WH-SXF12D6E5, Руководство по обслуживанию

Страница: 40 / 120

40
5. Once all wiring work has been completed, tie the cables and cord together with the binding strap so that they do not touch
other parts such as the compressor and bare copper pipes.
6. Install back the control board cover.
11.4.4.1. Wire Stripping and Connecting Requirement
• Same as indoor requirement. For details please refer the diagram on AIR-TO-WATER HEATPUMP INDOOR UNIT, section
11.3.4. (CONNECT THE CABLE TO THE INDOOR UNIT)
11.4.5. PIPE INSULATION
1. Please carry out insulation at pipe connection portion as mentioned in Indoor/Outdoor Unit Installation Diagram. Please wrap
the insulated piping end to prevent water from going inside the piping.
2. If drain hose or connecting piping is in the room (where dew may form), please increase the insulation by using POLY-E
FOAM with thickness 6 mm or above.
11.4.6. Disposal of Outdoor Unit Drain Water
• When a Drain elbow is used, please ensure to follow below:
- the unit should be placed on a stand which is taller than 50 mm.
- cover the 8 holes (ø20mm) with Rubber cap (refer to illustration below)
• If the unit is used in an area where temperature falls below 0 C for 2 or 3 consecutive days, it is recommended not to use the
Drain elbow and Rubber cap , for the drain water freezes and the fan will not rotate.