Help
57
Conversation
Problem
Cause & Solution
Page
Sound cuts in/out or fades.
L�
The surroundings of the main monitor station, the sub monitor
station, the door station or the camera are noisy. Try “Press-to-talk”
mode.
L�
The antenna on the sub monitor station is being covered with your
hand. Do not cover it.
L�
The sub monitor station or the camera is too far from the main
monitor station. Move closer to the main monitor station. If you
install a repeater (optional), the sound may be improved.
L�
There is an object such as a concrete wall obstructing the signal.
Move to a place without an obstacle. If you install a repeater
(optional), the sound may be improved.
L�
A microwave or wireless LAN appliance is in use. Move closer to the
main monitor station or use a sub monitor station or camera located
away from those appliances. Try again.
22
14
54
54
―
A howling noise interrupts the
conversation.
L�
A howling noise may occur when you are too close to the other
party. Move away from the other party.
―
Your voice cannot be heard by the
outside visitor. (Visitor’s voice can be
heard.)
L�
The “Press-to-talk” mode is activated. “P” is displayed on the main
monitor station or “ ” is displayed on the sub monitor station. Only
while pressing
{
TALK
}
, the outside visitor can hear your voice.
22
Voice answer mode does not operate
properly.
L�
Your voice is not loud enough or your initial reply is too long (must
be less than 1 second). Try a different voice volume or change
the length of your answer until the main monitor station or the sub
monitor station beeps.
22
Sub monitor station/Battery
Problem
Cause & Solution
Page
“ ” flashes and 2 short beeps sound.
L�
The battery level is low.
Charge the battery immediately.
18
Even if you place the sub monitor
station on the charger, the CHARGE
indicator does not light up.
L�
The AC adaptor is disconnected from the power outlet or the
charger. Plug the AC adaptor into the power outlet or the charger
firmly.
L�
The sub monitor station is not placed on the charger correctly.
Replace it securely. (A short beep sounds and the CHARGE indictor
lights in solid red.)
L�
The charge contacts are dirty. Clean them with a soft, dry cloth.
L�
The battery is new or discharged. Place the sub monitor station on
the charger and wait for about 60 seconds.
18
18
59
18
The CHARGE indicator does not go off
after the battery has been charged for
about 7 hours.
L�
When the power of the main monitor station is turned off or “OUT
OF RANGE” is displayed on the sub monitor station, the charging
time will become longer. Make sure the power of the main monitor
station is turned on, and charge the sub monitor station in a location
near the main monitor station where “OUT OF RANGE” disappears.
18
Even if the sub monitor station has
been charged, “ ” flashes after using
it a few times.
L�
The battery is at the end of its life. Replace the battery with a new
one.
60
The sub monitor station or the charger
is warm.
L�
This is normal. (It may feel a little warmer in summer than in winter.)
If it feels very hot, disconnect the AC adapter from the power outlet
and contact our service personnel.
―
VL-SW102BX_OI.indb 57
2006/06/12 15:36:20
