26
1
Turn your computer on
2
Press the disc eject button and slowly pull out the tray
Setting a Disc
Title-side up
Do not apply excessive force to the tray in the open position, doing so could
damage the tray.
Center Holder
Eject Button
CAUTION
CD Drive
If the vibration of the CD drive is excessive, set [CD Drive Speed] to [Low] in the
Setup Utility.
For AutoPlay CDs:
• If an AutoPlay CD does not start after the computer resumes from the standby
or hibernation modes, remove the disc from the drive, then reinsert the disc
again after a 15 second wait.
• An AutoPlay CD may start during file access, depending on the status of the disc.
When playing back movies from a disc, note that smooth playback may not be
possible in some cases.
If the CD drive has not been accessed within 90 seconds, the drive motor will automati-
cally shut down to reduce the power consumption. When the CD drive is accessed
once again, the power of the drive motor is turned on. However, approximately 30
seconds are required until data is actually read from the disc.
Power-saving Mode
NOTE
3
Place the disc securely on the center holder
4
Close the tray
Before using the drive for the first time, remove the protective sheet
from the lens area. The protective sheet inside the drive delays the
opening of the drive by about ten seconds. This delay is not a problem.
NOTE
