15
Security Measures
Setting the User Password
(enabling, changing, disabling)
1
Run the Setup Utility
(
page 48
)
2
Using either or , select [Security]
3
Using either or , select [Set User Password] and press
Enter
4
<Only when the User Password has been set>
Enter your password at [Enter Current Password] and press
Enter
5
Enter your password at [Enter New Password] and press
Enter
<When the Setup Utility is started up with the Supervisor Pass-
word>
To disable the User Password
Press only
Enter
6
Re-enter your password at [Confirm New Password] and press
Enter
<When the Setup Utility is started up with the Supervisor Pass-
word>
To disable the User Password
Press only
Enter
7
At [Setup Notice], press Enter
8
Press F10 and select [Yes], then press Enter
When the Supervisor Password has not been set, the User Password can not be
set. Set the Supervisor Password if you have not done so. (
page 14
)
NOTE
Your password will not be displayed on the screen.
Only up to seven alphanumeric characters can be used.
•
There is no distinction between upper and lower case letters.
•
Use only the upper horizontal row of numeric keys to input your password.
•
Do not input your password while holding down
Shift
or
Ctrl
.
When you do not want the User Password enabled or changed without
permission:
1
Run the Setup Utility and enter the Supervisor Password.
2
Using and , select [User Password Protection] in [Security] menu and
press
Enter
.
3
Using and , select [Protected] and press
Enter
.
NOTE
Do not forget your password. If a password is forgotten, you will be unable to use
your computer. If this happens, ask a person who knows the Supervisor Pass-
word.
When running the Setup Utility, do not leave your computer even for a short time,
as the possibility exists for the password to be set/changed by another person.
CAUTION
