EN37
Replacing the Cartridge
Engli
sh
Replace the cartridge without disconnecting the power plug.
(The cartridge life cannot be reset when the power plug is disconnected.)
Do not replace the cartridge with the condition of main unit fl at.
Do not place the main spout upwards.
Before replacing the cartridge, turn off the faucet. Do not run water through the
Alkaline Ionizer with the cartridge removed.
(Doing so will cause the water to overfl ow.)
1
Remove the cover, and then
remove the cartridge.
Take care since water will drip from the
cartridge. Water may also emerge from the
bottom of the unit (this does not indicate that
there is a leak).
Do not place the unit on its side or upside down
with the cartridge removed (since water may get
inside the unit and cause malfunction).
Push
slightly
Cover
Push down on the top
Pull toward you
Pull up and out
Cartridge
2
Install the new cartridge.
After putting the cartridge in place, push it up.
New cartridge
Push up
Align the center of the bottom of the cartridge
with the center of the cartridge hole, and
while pressing it down, push the cartridge in.
3
Press
(for about 3 seconds)
.
The “Reset completed” display appears, and
about
3 seconds later
the “Cartridge life” display appears.
Refer to the displays on the right, and check whether
the remaining cartridge life has been reset correctly.
Reset completed
screen
Cartridge life
display
4
Open the faucet, and
run purifi ed water through the Alkaline
Ionizer
(for about 3 or 4 minutes).
When water is run through the Alkaline Ionizer, “Preparation
time” blinks for about 20 seconds on the LCD display.
While water is running through the Alkaline Ionizer, check
that water is not leaking from the area where the cartridge
was installed and that water is coming out of the drain outlet.
Continued on next page
Drain outlet
LCD display
TK-AS66-ZEX̲En.indb 37
TK-AS66-ZEX̲En.indb 37
2017/01/30 15:04:23
2017/01/30 15:04:23
