EN25
For Your Operating Convenience
Engli
sh
Each time water is run through the Alkaline Ionizer, the total water output (amount of water that comes
out of the main spout) is calculated and indicated on the LCD display in 0.1-liter increments. (Water
output display)
In measuring the water output, it is recommended that you set the main spout and acidic water
spout as instructed in the procedure on P. EN26 (in order to improve the accuracy of the water
output display).
1
Turn off the faucet, and press
repeatedly until “Water
output” is displayed.
Each time the button is pressed, the
display on the LCD changes.
2
Press the desired water quality
selector button, and then turn on the
faucet.
As soon as the “Preparation time” display
is cleared, the measuring begins.
3
Measure the water output.
While the output is being measured, the
water output buzzer
sounds once for
every 0.2 liter or so of water output.
4
Turn off the faucet when the water
output display reaches the fi gure to
be measured.
e.g.)
To turn off the water output buzzer
Refer to “How to set” (P. EN31), and set “Water
output buzzer” to “OFF”.
Important
If there is too large a discrepancy between
the water output display and actual water
output, perform “Correcting the water output
display” (P. EN28).
Water quality selector buttons
Water output display
e.g.)
Measuring the water output volume
TK-AS66-ZEX̲En.indb 25
TK-AS66-ZEX̲En.indb 25
2017/01/30 15:04:18
2017/01/30 15:04:18
