EN14
Installing the Alkaline Ionizer (continued)
Remove the hose fastening nut from the bypass
selector, and pass the hose through the nut.
Insert the water supply
hose into the bypass
selector as far as it will go.
Tighten up the hose fastening nut securely.
1
After completing the preparations,
connect the water supply hose.
4
Install the acidic water stand.
2
Secure the water supply
hose
(using the hose strap)
.
Insert the acidic water and drain hoses securely.
Attach the stand to the side of the sink.
(If the suction disc slips off , stick the
mounting disc
onto the side of the sink.)
Connect the hoses as instructed on the label.
Do not place a waste container or other such
objects underneath the acidic water stand.
The acidic water spout must be below the level
of the bottom of the unit and the diff erence
in height between the main spout and acidic
water spout must be greater than
10 cm and
less than 50 cm
(so that the appropriate pH
level (ion concentration) is achieved).
Mounting
disc
Adhere to the
side of the sink.
Acidic
water spout
Bottom
of unit
Height diff erence
Main spout
Acidic water and
drain hoses
Acidic water
stand
Light gray
Dark gray
Label
Hold here
Detach here
How to remove the acidic water stand
Do not use any tools for this assembly (since the
hose fastening nut may be damaged).
OK
NG
Gap
Installation position
TK-AS66-ZEX̲En.indb 14
TK-AS66-ZEX̲En.indb 14
2017/01/30 15:04:14
2017/01/30 15:04:14
