36
English
Note
●
Inputs set for [Input skip settings] or inputs when each
function is disabled cannot be selected. (see page 61)
●
Displays the signal name as set in [Input label]. (see
page 60)
●
Input will not be switched unless [Input lock] is set to
[Off]. (see page 67)
●
To switch between the component (color difference)
video and RGB for the PC IN terminal, make the
setting with [Setup] - [PC input mode]. (see page 86)
●
Image retention may occur on the LCD liquid crystal
panel when a still picture is kept on the panel for
an extended period. To prevent such a problem,
using the screensaver and the [Wobbling] function is
recommended. (see page 59, 60)
●
Switching to another input while the unit is connected
to Screen Transfer with Screen Transfer input will
break the connection. Check the connection again
after switching the input.
●
When [Whiteboard settings] - [Whiteboard] is set to
[On], the WHITEBOARD input is enabled. (see page
71)
RECALL
It is possible to check the setting status of input label,
picture mode, etc.
Press <RECALL>.
Current setting status will be displayed.
10:00
1
2
7
8
3
4
5
6
HDMI1
Full
AUDIO IN
Memory name: MEMORY2
Schedule play mode
Off timer
90 min
Backup mode OK
1
Input label
2
Aspect mode (see page 38)
3
Backup input change (see page 58)
4
Audio input (see page 63)
5
Profile name (see page 51)
6
[Schedule play mode] (see page 124)
7
Off timer remaining time (see page 37)
8
Clock / Mute (see page 37, 73)
●
When there is no video signal to the selected input,
[No signal] is displayed for about 30 seconds at the
end.
●
When a USB memory is not connected to the USB
terminal at the time of switching to the USB input, [No
external media] is displayed for about 30 seconds.
Even when a USB memory is connected, if it does not
contain any playable file, [No play file] is displayed at
all times.
●
When [No signal image settings] - [Display setting] is
set to [On] (see page 66), the message [No signal] /
[No external media] / [No play file] are not displayed.
Instead, the image set in [No signal image settings]
will be displayed.
●
To display the clock, set [Date and time] and then set
[Clock display] to [On]. (see page 73)
