Panasonic PT-MZ13K, Руководство по эксплуатации

Страница: 58 / 248

Chapter 3 Basic Operations — Switching on/off the projector
58 - ENGLISH
Initial setting (operation setting)
Set the items regarding the operating method depending on the duration of use and the usage of the projector.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP]
menu
→
[OPERATION SETTING]. If you change the settings while using the projector, the duration until the
brightness decreases to half may shorten or the brightness may decrease.
This initial setting (operation setting) is prepared to complete the settings simply at once during the installation
when the operation of the projector is predetermined. This cannot set all the items regarding the operation setting.
When the detailed setting is required or setting change is required, ask the person responsible for this projector
(such as a person in charge of equipment or operation).
2/7
100.0%
INITIAL SETTING
SET
CHANGE MENU SELECT
OPERATING MODE NORMAL
ENTER
LIGHT OUTPUT
Set the way to use the projector. For details, please
refer to the operating instructions "When the initial
setting screen is displayed".
Note
f
For the relationship between the brightness and the runtime, refer to “Relationship between brightness and runtime” (
x
page 59).
f
For details on each setting item, refer to the [PROJECTOR SETUP] menu → [OPERATION SETTING].
1) Press
as
to select [OPERATING MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL] Set this item when the brightness is required. The estimated runtime is approximately 20 000 hours
*1
.
[QUIET]
The brightness will decrease compared to [NORMAL], but select this item when operation with low
noise is prioritized. The estimated runtime is approximately 20 000 hours
*1
.
[USER1]
Set [LIGHT OUTPUT] as desired. [USER2]
[USER3]
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust.
The value of runtime is just an estimate, and is not the warranty period.
3) Press
as
to select [LIGHT OUTPUT].
4) Press
qw
to adjust.
Operation
Adjustment
Range of adjustment
Brightness Runtime (estimate)
Press
w
. The screen becomes brighter. The runtime becomes shorter.
8.0 % - 100.0 %
Press
q
. The screen becomes darker. The runtime becomes longer.
5) Press the <ENTER> button to proceed to the initial setting.