Panasonic PT-JW130FBE, Инструкция по эксплуатации (Функциональное руководство)

Страница: 72 / 217

Chapter 4 Settings — [SETUP] menu
72 - ENGLISH
Setting [NO SIGNAL SHUT-OFF]
(Only in the projector mode)
This function automatically switches the power of the projector to standby if the input is HDMI and there is no input
signal for a certain period of time. The time before switching to standby can be set.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [NO SIGNAL SHUT-OFF].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[10MIN.] - [90MIN.] Sets the time in 10-minute intervals.
[DISABLE] Disables [NO SIGNAL SHUT-OFF].
Note
f
If the input is set to other than HDMI, [NO SIGNAL SHUT-OFF] is disabled.
f
The factory default setting for [NO SIGNAL SHUT-OFF] is [10MIN.].
Setting [STANDBY MODE]
Set the power consumption during standby.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [STANDBY MODE].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ECO] Select this item to reduce power consumption during standby.
[NETWORK]
Select this item to reduce power consumption during standby, and to operate the projector via wired
LAN using the Wake on LAN function.
[NORMAL]
Select this item to use the network function during standby.
Or, select this item to synchronize with the NTP server and adjust the date and time of the projector
automatically.
Note
f
When [ECO] is set, network functions are not available during standby.
f
When [ECO] is set, there may be a delay in displaying when the power is turned on, compared to when [NORMAL] is set.
f
When [NETWORK] is set, the Wake on LAN function enables the network function available for 60 seconds even during standby.
f
When [NORMAL] is set, the internal cooling fan may run during standby.
f
The [STANDBY MODE] setting is not reset to the factory default even when [ALL USER DATA] is executed from the [SETUP] menu →
[INITIALIZE] (
x
page 76).
f
If the following three settings are made, the image will disappear temporarily when synchronizing with the NTP server once after you have
turned on the power or the power has been turned on.
g
Setting [STANDBY MODE] to [ECO] or [NETWORK]
g
Setting the [SETUP] menu → [DATE AND TIME] → [ADJUST CLOCK] → [NTP SYNCHRONIZATION] to [ON]
Refer to “Setting the date and time automatically” (
x
page 75) for details.
g
Setting the input to signage
[INITIAL STARTUP]
Set the startup method when the power supply of the interior wiring is turned on or when the plug of the power
cord is connected to an outlet.
1) Press
as
to select [INITIAL STARTUP].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.