Panasonic PT-JW130FBE, Инструкция по эксплуатации (Функциональное руководство)

Страница: 42 / 217

Chapter 3 Basic Operations — Turning on/off the projector
42 - ENGLISH
Turning on the projector
2)
2)
2)
r
When using the optional Ceiling Kit
1) Turn on the power supply of the interior wiring that is connected to the projector.
f
The power indicator <ON (G)/STANDBY (R)> lights in red, and the projector enters the standby mode.
2) Press the power <
v
/
b
> button.
f
The power indicator <ON (G)/STANDBY (R)> lights in green and the projection is soon started.
r
When using the optional Floor Stand Kit
1) Connect the power cord connected to the projector to an outlet
f
The power indicator <ON (G)/STANDBY (R)> lights in red, and the projector enters the standby mode.
2) Press the power <
v
/
b
> button.
f
The power indicator <ON (G)/STANDBY (R)> lights in green, and the projection is soon started.
Attention
f
When turning on the projector, take notice of the people around the projector and ensure the light from the light source will not flash into
their eyes.
Note
f
The initial setting screen is displayed when the projector is turned on for the first time after purchase or when [ALL USER DATA] in the
[SETUP] menu → [INITIALIZE] is executed. Refer to “When the initial setting screen is displayed” (
x
page 42).
f
The operating range of the remote control is approx. 7 m (22'11") when operated directly in front of the signal receiver. For the range that
can be operated with the remote control, refer to “Operating range of the remote control” (
x
page 29).
f
It may take longer for the projection to start when the [SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or
[NETWORK] when compared set to [NORMAL].
f
When the power is turned on or an input signal is switched, you may hear a high-frequency driving sound. This is not a malfunction.
f
When the [SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY], the power indicator <ON (G)/STANDBY (R)> lights in green and
the projection is soon started when the projector was turned off by directly turning off the power supply of the interior wiring or disconnected
the power plug from the outlet while projecting in previous use, and the power supply is turned on or the power plug is connected to the
outlet again.
When the initial setting screen is displayed
The initial setting screen is displayed when the projector is turned on for the first time after purchase or when [ALL
USER DATA] in the [SETUP] menu → [INITIALIZE] is executed. Set the following according to the circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <RETURN> button while the initial setting screen is displayed, you can go back to the previous
screen.
Focus adjustment
Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom.
Refer to “Adjusting the projection” (
x
page 48) for details.