Panasonic PT-DZ13KU, Руководство по эксплуатации

Страница: 23 / 187

Chapter 1 Preparation — Start-up display
ENGLISH - 23
Initial setting (installation setting)
Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to “Installation mode” (
x
page 31)
for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') or higher and lower than 2 700 m
(8 858') above sea level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1) Press
as
to select an item.
2) Press
qw
to switch the setting.
ENTER
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
It may shorten the life of the lamp and projector if used
in incorrect setting.
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
INITIAL SETTING
SET
CHANGE MENU SELECT
PROJECTION METHOD
COOLING CONDITION
FRONT/FLOOR
AUTO
HIGH ALTITUDE MODE OFF
3) Press the <ENTER> button to proceed to the initial setting.
Initial setting (screen setting)
(Only for PT-DZ13KU, PT-DS12KU, PT-DZ10KU)
Set the screen format (aspect ratio) and display position of the image. After completed the initial setting, you can change the settings of each
item from the [DISPLAY OPTION] menu → [SCREEN SETTING].
1) Press
as
to select an item.
2) Press
qw
to switch the setting.
ENTER
16:10
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGE MENU SELECT
SCREEN FORMAT
f
[SCREEN FORMAT] (
x
page 97)
f
[SCREEN POSITION] (
x
page 97)
3) Press the <ENTER> button.
f
Confirm the setting value and complete the initial setting.
Note
f
If you press the <MENU> button on the initial setting screen, you can go back to the previous screen.
f
To continue operations after completed the initial settings, refer to “Selecting the input signal” (
x
page 56).
f
By default, the time zone of the projector is set to +09:00 (Japan and Korean Standard Time). Change the setting in the [PROJECTOR
SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.