Panasonic LJ-SK56A, Руководство по установке, Страница: 65 / 132

65
Installation Manual
[Display Mode]
• In the display mode, change the level setting to be edited (Network Adaptor connection setting/Communications
ID setting). Press "CLOCK (▼)" or "DATA (▲)" in the display mode to cycle through items. (c1. Network Adaptor
connection display / c2. Communications ID display)
• The item number and the current parameter are displayed.
• Select the desired item to change its parameter and press "MENU (ENTER)" to switch from the display mode to the
parameter setting mode.
[Setting Mode]
■
c1: Network Adaptor Connection Setting
• In the display mode, set the focus to the Network Adaptor connection and press "MENU (ENTER)" to switch to the
Network Adaptor connection setting mode.
The setting value blinks.
• Press "CLOCK (▼)" or "DATA (▲)" to change the selected (i.e. blinking) value.
Set the value by referring to Table below.
• After editing the setting, press "MENU (ENTER)" to apply the new parameter value and return to the Network
Adaptor connection display mode.
•
Press "ON/OFF (CANCEL)" to abort the setting. Note that the changed values are discarded if you abort the setting.
No Setting Item Setting Description
Factory
Default Setting
c1
Network Adaptor
Connection Setting
0 Not Connected
0
1 Connected
■
c2: Communications ID Setting
• In the display mode, set the focus to the Communications ID and press "MENU (ENTER)" to switch to the
Communications ID setting mode.
The setting value blinks.
• Press "CLOCK (▼)" or "DATA (▲)" in the Communications ID setting mode to change the selected (i.e. blinking)
value.
Set the value by referring to Table below.
• After editing the setting, press "MENU (ENTER)" to apply the new parameter value and return to the
Communications ID display mode.
• Press "ON/OFF (CANCEL)" to abort the setting. Note that the changed values are discarded if you abort the setting.
• Set to 1 when connecting the Network Adaptor.
If it is set to anything other than 1, then the Network Adaptor cannot be connected to.
No Setting Item Setting Description
Factory
Default Setting
c2
Communications ID
Setting
1 to 30
ID value for Network
Adaptor Communications
1
[Settings Complete]
• Press "ON/OFF (CANCEL)" in the display mode to return to the parameter item selection mode.
by qualified personnel.
value specified in this setting, regardless of
6-6. Remaining Battery Level Setting
This setting can be used to set the remaining battery level to be reserved for the event of a prolonged power outage.
No discharging is performed when the remaining battery is lower than the
the operation mode (i.e. gird or stand-alone).
• During remote-control system mode, discharging is stopped at the level of remaining battery level adding 2 for
blackout.
● Since normal operations will no longer be operable when the set value is lower than the set remaining battery if
the remaining battery is set via the remaining battery level setting, be careful in setting this.
● The work must be performed
■
Preparation
See 6-2 to 6-4 and switch to the parameter item selection mode showing the initial display [no1-1]. Then select [no1-2]
and press "MENU(ENTER)" to switch "Remaining Battery Level [Prb **]".
■
Operation Procedure
Parameter Item
Selection (See 6-4)
* Only while [no 1-2] is
being displayed
(1) Indicates that this is a
remaining battery level
setting.
(2) Displays the current
setting value.
Display Example
(1)
Display Mode
Remaining Battery Level
(Initial Display) Remaining Battery
Level Setting
Setting Mode
or
(2)
or