[Scan mode]
Select "Full scan" or "Partial scan" for the scan mode of
JPEG/MPEG-4 images.
Default:
Full scan
Full scan
Images of up to 1280 (H) x 960 (V) pixels can be cap-
tured. The frame rate will be limited to up to 15 frames
(per second) since the progressive scan is used.
Note:
The refresh interval of analog video output will also
become slow.
Partial scan
Images of up to 960 (H) x 720 (V) pixels can be cap-
tured at high speed (up to 30 frames per second for net-
work output, up to 60 fields per second for analog out-
put). Fast scanning is achieved since the center of the
CCD is scanned by the interlace scanning.
Notes:
• A motion adaptive interlace/progressive conversion
will be made for network output.
• Angular field of view will be narrower comparing with
the full scan mode since the effective scanning area
turns from 4.8 (H) x 3.6 (V) mm to 3.6 (H) x
2.7 (V) mm.
[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image
from the following.
0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps/2 fps/3 fps/5 fps/
6 fps */10 fps */15 fps */30 fps *
Default:
5 fps
Note:
When "ON" is selected for "MPEG-4 transmission",
the refresh intervals may be longer than the set
value when the setting value with an asterisk (*) on
the right is selected.
23
Configure the settings relating to images and audio [Camera
setup]
The settings relating images and audio such as brightness and image quality of JPEG/MPEG-4 can configured on
this page.
The "Camera setup" page has 3 tabs of the [JPEG/MPEG-4] tab, the [Camera] tab and the [Audio] tab.
Configure the settings relating to JPEG image [JPEG/MPEG-4]
Click the [JPEG/MPEG-4] tab on the "Camera setup" page.
Configure the settings such as "Refresh interval (JPEG)", "Image capture size" and "Image quality" on this page.
Refer to page 25 for further information about the settings relating to MPEG-4 images.
Full scan
Partial scan
Center clipping
Interlace scan
960 (H) x 720 (V)
1280 (H) x 960 (V)
