52
Configure the Camera Settings such as Image Quality, Brightness, etc.
The following are descriptions of how to configure the settings such as image quality, brightness, privacy zone and
flange-back length, etc.
The settings can be configured in the following methods.
• Configure the settings using a PC
The setting can be configured on the [Camera] tab of the "Camera setup" page. Refer to page 27 for further infor-
mation.
• Configure the settings using the operation buttons on the camera
The settings can be configured on the "CAMERA SETUP" page displayed on a video monitor connected to the
video output connector. Refer to the operating instructions for further information.
Note:
The illustrations below are the examples of the setup pages to be displayed on a video monitor.
Configure the settings relating to the camera operations
[CAMERA SETUP]
Configure the settings relating to camera operations. The settings can be configured on the "CAMERA SETUP"
page.
Refer to the operating instructions or page 27 for descriptions of how to display the "CAMERA SETUP" page.
CAMERA SETUP page
[CAMERA ID]
Select "ON" or "OFF" to determine whether to enable or
disable the camera title display. When "ON" is selected,
the set camera title will be displayed. Refer to page 59
for descriptions of how to edit the camera title.
Default:
OFF
Number of characters for the camera ID:
16 charac-
ters
[ALC/ELC]
Select the light control method from the following
according to the lens in use.
Refer to page 60 for descriptions of how to compensate
backlight.
ALC:
Auto backlight compensation controls light
amount according to brightness of subjects. When
using an ALC lens, select this parameter.
ALC+:
Auto backlight compensation and the electronic
shutter control light amount according to brightness
of subjects. When shooting bright subjects using an
ALC lens, select this parameter.
Note:
When shooting under fluorescent lamps, flicker may
occur.
ELC:
When using a fixed iris lens, select this parameter.
Default:
ALC
[SHUTTER]
Select the shutter speed.
The following will be available by changing the shutter
speed.
When a fast shutter speed (up to 1/10000) is set, the
camera can shoot a fast motion of a subject without out-
of focus blur.
When shooting under fluorescent lamps (operating at
50 Hz), flicker may occur. When the faster shutter
speed is set, flicker may be caused more frequently. By
setting the shutter speed to "1/50" or "1/100", flicker
caused by fluorescent lamps can be diminished.
**CAMERA SETUP** 1/2
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
DNR HIGH
BW MODE
PRIVACY ZONE OFF
EL-ZOOM OFF
**CAMERA SETUP** 2/2
STABILIZER OFF
RET TOP END
