Panasonic AU-EVA1E, Руководство по эксплуатации

Страница: 86 / 175

– 86 –
Chapter 4 Operation — Menu setting contents
[START] The beep sound is generated only when the recording is started.
[STOP] The beep sound is generated only when the recording is stopped.
[START&STOP] The beep sound is generated when the recording is started and stopped.
(Factory setting: [OFF])
[VOLUME]
Sets the volume of the beep sound when starting or stopping the recording.
The items that can be set are as follows.
f
[HIGH], [MED], [LOW]
(Factory setting: [MED])
[ALARM]
[BATTERY END]
Sets if the alarm is to be sounded when the remaining battery level is exhausted.
The items that can be set are as follows.
f
[HIGH], [MED], [LOW], [OFF]
(Factory setting: [MED])
[MEDIA END]
Sets if the alarm is sounded when the remaining recordable capacity of the SD card is exhausted.
The items that can be set are as follows.
f
[HIGH], [MED], [LOW], [OFF]
(Factory setting: [MED])
@ @ NOTE
t
Volume of the alarm during system error is fixed to [MED].
[OUTPUT SETTINGS] menu
Sets the display content or output format of the video.
[SDI OUT]
[OUTPUT SW]
Enables/disables the output from the <SDI OUT> terminal.
[ON] Outputs the video.
[OFF] Does not output the video.
(Factory setting: [ON])
[SIGNAL SEL]
Sets the output from the <SDI OUT> terminal.
[SDI] Outputs the signal set in [OUT FORMAT] of [SDI OUT].
[LCD(1080p)] Outputs the video displayed on the LCD monitor in 1920 × 1080p.
[LCD(1080i)]
Outputs the video displayed on the LCD monitor in 1920 × 1080i.
(Factory setting: [SDI])
[OUT FORMAT]
Selects the signal to be output from the <SDI OUT> terminal. The items that can be selected differ depending on the setting in the [SYSTEM
SETTINGS] menu
→ [SYSTEM MODE] → [FREQUENCY]/[MAIN PIXEL].
[4096x2160p] Outputs in 4096 × 2160p.
[3840x2160p] Outputs in 3840 × 2160p.
[1920x1080p] Outputs in 1920 × 1080p.
[1920x1080i]
Outputs in 1920 × 1080i.
[1920x1080PsF] Outputs in 1920 × 1080PsF.
[1280x720p] Outputs in 1280 × 720p.
(Factory setting: [1920x1080PsF])
@ @
NOTE
t
For the combination that can be set, refer to “Format that can be output from the <SDI OUT> terminal”.