Palmgren 9683408, Руководство по эксплуатации и список запасных частей

Страница: 11 / 40

REMOVE/REPLACE/ALIGN THE TABLE INSERT
Refer to Figure 5a-5b
• Turn the height-adjusting knob counterclockwise to lower the
blade all the way.
• Lock the blade by turning bevel lock lever clockwise.
•
To remove the table insert: Turn the lock knob (1) clockwise to
unlock the table insert (2). Place your index finger in the hole,
pulling the table inserts out toward the front of the saw.
•
To reinstall the table insert:
Push the table insert (2) down and
turn the lock knob (1) counter-clockwise to lock the table insert in
place.
If the table insert is not level with the saw table, using a 2.5 mm hex
key (not supplied), adjust the four set screws (3) pre-assembled to
the table located on the four holes of the table insert until the table
insert is level with the working table.
WARNING!
The table insert must be level with the saw table. If the table insert
is too high or too low, the workpiece can catch on the uneven
edges, resulting in binding or kickback, which could result in
serious personal injury.
ATTACH THE TABLE SAW TO THE STAND
Refer to Figure 3d-3e
• Place the stand on a level surface, and adjust three levelling feet
(1) in order to stabilize the stand with respect to the level surface.
Turning clockwise will lower levelling foot (1). Turning
counter-clockwise will raise levelling foot (1).
HEIGHT/BEVEL ADJUSTING HANDWHEEL
Refer to Figure 4
• Turn the height-adjusting knob (1) clockwise to raise the blade
and counter-clockwise to lower the blade.
• Place the table saw on top of the stand and align the mounting
holes at the base of the table saw with corresponding holes in the
stand.
• Insert four hex bolts (2) along with flat washers (3) into the
aligned holes and tighten the bolts.
11
PALMGREN Operating Manual & Parts List 9683408
• Turn the handwheel (2) clockwise to move along the arc rail
causing the blade to bevel from 0 – 45°, or turn counter-clockwise
to reduce the bevel angle.
• Secure the blade bevel lock lever (3) when the bevel angle pointer
points at desired angle on scale. To lock the blade, turn blade
bevel-lock lever clockwise.
To unlock the blade, turn it counter-clockwise.
Figure 4
Figure 3c
Figure 3d
Figure 3e
Figure 5a
2
1
1
3
2
2
3
1
1
2