Palmgren 9683408, Руководство по эксплуатации и список запасных частей

Страница: 14 / 40

CHECK THE ALIGNMENT OF THE RIP FENCE TO THE BLADE
Refer to Figure 11
• Unplug the saw.
• Remove the blade guard assembly and anti-kickback pawls
assembly.
• Raise the locking handle (1) to allow the rip fence (2) to be moved.
• Place the framing square (3) beside the blade, and move the rip
fence up to the square. Note the measurement on the rip scale.
• Move the fence back and rotate the framing square (3) 180° to
check the other side.
• If the two measurements are not the same, loosen the two socket
head bolts (4) on the rip fence and then align it.
• Retighten the two socket head bolts (4).
• Replace the blade guard assembly and anti-kickback pawls
assembly.
• Make two or three test cuts using scrap wood. If the cuts are not
true, repeat the process.
USE SUB FENCE ASSEMBLY (FOR RIP CUTTING NARROW
WORKPIECE)
Refer to Figure 12
When ripping a narrow workpiece, it is necessary to attach the sub
fence assembly to the rip fence to prevent hands from getting too
close to the blade.
• Pull up the locking knob (1) on the sub fence assembly (2).
• Align the slot of sub fence assembly (2) with the rip fence (3), and
push the sub fence assembly (2) down.
• Lock it in place by pushing down lock knob (1).
• Sub fence assembly (2) can be mounted on left or right side of the
rip fence (3).
• When not in use, store the sub fence assembly in storage position.
14
PALMGREN Operating Manual & Parts List 9683408
RIP FENCE INSTALLATION AND USE
Refer to Figure 10a-10b
INSTALLATION:
• Loosen the rip fence (1) by lifting up the locking handle (2).
• Place the rear lip (3) on the rear of the saw table and pull slightly
toward the front of the unit.
• Lower the front end of the rip fence onto the guide surfaces on
top of the front rail.
• Check for smooth gliding action.
• Push the locking handle down and secure the fence. When
securely locked, the locking lever should point downward. Check
for a smooth gliding action. If adjustments are needed, see the
section “ CHECK THE ALIGNMENT OF THE RIP FENCE TO THE
BLADE ”.
• Make two or three test cuts using scrap wood. If the cuts are not
true, repeat the process.
NOTE:
The rip fence must be secure when the locking handle is
engaged. To increase the grip of the rip fence on the rear lip of the
table, tighten the clamp screw (4) on the rear of the rip fence by
turning it clockwise.
USE:
• Loosen the rip fence (1) by lifting the locking handle (2) up.
• Move the rip fence to the desired distance from the blade and
ensure the rip fence is level on the working table.
• Push the locking handle (2) down to secure the fence. When
securely locked, the locking handle should point downward.
WARNING! To reduce the risk of injury, always make sure the rip
fence is parallel to the blade before beginning any operation.
Figure 10a
Figure 10b
Figure 11
Figure 12
1
3
2
4
1
2
4
3
1
2
4
1
2
3