Palmgren 9683408, Руководство по эксплуатации и список запасных частей

Страница: 16 / 40

USE THE RIGHT EXTENSION TABLE
Refer to Figure 16
• Loosen the locking knobs (1) under the work table.
• Slide the extension table (2) in or out until the extension pole (3)
is positioned at the desired distance.
• Tighten the locking knobs (1).
INSTALL THE REAR OUT-FEED SUPPORT
Refer to Figure 17a-17b
• Insert the two rear extension table poles (1) into the two holes of
the rear out-feed support (2).
• Snap the two locating seats (3) over the two rear extension table
poles (1). Verify that the locating pins in the locating seat fits into
the corresponding holes in the rear extension table poles (1).
• Insert the rear extension table poles (1) into the two holes in the
rear of the work table and into the extension tube brackets that
are located under the work table. Position the rear extension
table.
• Thread the locking knobs (4) into the holes under the work table
and tighten them.
• Thread the two stop screws (5) into the holes located on ends of
the rear table extension poles (1) and tighten them.
USE REAR OUT-FEED SUPPORT
Refer to Figure 18
Loosen the locking knobs (1) under the work table, slide the rear
out-feed support (2) in or out until the rear extension table pole (3)
is positioned at the desired distance and tighten the locking knobs
(1).
• When ripping a short workpiece, the rear extension table should
be positioned as close to the rear of the work table as possible.
• When ripping a long workpiece that requires extra support to
accept the cut workpieces, the rear out-feed support should be
pulled out as far as possible, until the locating seat locks the
movement of the rear out-feed support.
16
PALMGREN Operating Manual & Parts List 9683408
Figure 15
Figure 16
Figure 17a
Figure 17b
Figure 18
2
1
4
3
2
3
1
3
2
1
1
4
5
2
3
2
1