020-17467-00 Instructions For Use PadMixer 1000 Premium RevD
6 Cleaning, maintenance and inspection activities
6.1 Cleaning
The steel frame of the machine consists of 316 stainless steel and may be cleaned with
water, isopropyl alcohol, acetone or other solvents typically used for the cleaning of stainless
steel.
The Touch Panel should be cleaned with water or isopropyl alcohol only, preferably with a
damp cloth (i.e., not with acetone or other corrosive products).
6.2 Maintenance and inspection
The only preventive maintenance is the oil change. Only changing the oil of the motor reducer
is necessary (recommended every 10,000 hours). For detailed information, please consult
the technical datasheet of the motor.
It is recommended that the operation of the mixing biocontainer detection sensor is checked
before each operation and the operation of the emergency stops once a week (emergency
stop button and protective front cover).
It is recommended to perform the spindle calibration when the system displays the message
to do so.
With the technical binder, a list of spare parts is supplied. These are mainly parts that are
wearing parts, although the wearing is very limited. The changeover time is very much
depending on the way the mixing system is used
(RPM’s, mixing angle used, etc..), so the
changeover time is not specified. These parts can be ordered at PALL-Lifesciences.
The cleaning and maintenance of the machine can only be conducted when the machine has
been turned off. The power supply must be cut.
6.3
R
etrieving a lost password
In case the password is lost or changed by mistake, one can always find the active
password back in the menu of the Factory Settings: In the lower right hand corner of the
screen one can see the current active password.
6.4 Replacing the printer roll
To replace the printer paper, open the bottom cover plate of the machine.
Remove the white front plastic plate, remove the empty roll, replace by a new roll and replace
the plastic plate. Insert the film in the printer as shown on the picture. If the power of the
machine is switched on, the printer will automatically pull the paper inside.
