27
Palax C750
Translation
1-2018
9.9
Tightening the ínfeed conveyor belt, Fig. 19A
There are tightening screws between the infeed conveyor and the extension deck,
which can be used for tightening the belt.
As you tighten the belt, make sure that the belt travels in the centre of the roller.
Ensure that the scraper C is as close to the roller as possible. The scraper is intended
for always keeping the roller clean and ensuring that the belt runs straight.
Using the adjustment screw (19B) at the blade end of the feeder belt, you can change
the course of the band so that it will run straight.
9.10
Replacement of the infeed conveyor belt
1. Disconnect the hoses from the hydraulic motor.
2. Protect the couplings in order to prevent contaminants from entering the hoses.
3. The infeed conveyor is attached by 5 screws. Remove the screws and lower the
conveyor to the ground on wooden supports.
4. Loosen the tightening screws for the belt.
5. Change the belt. Note. Only use a conveyor belt obtained from an authorised
dealer.
6. Put the conveyor back in place, connect the hydraulic hoses and tighten the belt.
9.11
Direction of rotation of the belt
Check the correct direction of rotation of the belt in accordance with the arrow, while
replacing the belt.
During the infeed operation, the belt must run in the direction of the arrow.
The belt joint may break, if the belt is installed in the wrong way.
Check the belt for tightness at regular intervals.
The drive roller must not slip.
9.12
Changing the oil in the angular gear
1. Remove the oil plug, Fig. 20, and drain the used oil, for example, by using a suction
drainage device or removing the angular gear in its entirety.
19B
17
A
B
Содержание C750 Ergo
Страница 33: ...33 Palax C750 Translation 1 2018 12 Electric diagrams ...
Страница 34: ...34 Palax C750 Translation 1 2018 ...