Palax C750 Ergo, Инструкция по эксплуатации

Страница: 11 / 34

11
Palax C750 Translation 1-2018
1.9 Responsibilities of the operator
The machine may only be used to produce firewood.
All the safety-related devices are necessary to ensure a sufficient level of safety.
The PALAX C750 is a very safe machine provided that the instructions supplied are
properly followed, the regular maintenance routines are duly executed and the work is
carried out without haste.
It is the responsibility of the operator to ensure before the work is started that all the
safety-related devices are in perfect order and the machine has been serviced in a due
manner.
The operator is responsible for ensuring that no one else is subjected to any danger.
Modifying the construction of the machine is prohibited.
The machine must never be operated under the influence of alcohol or drugs.
Remember that as the operator you are responsible for any injuries caused if safety-
related devices have been removed from the machine.
1.10
Operating conditions
Always place the machine on as level a surface as possible.
Prevent risks, such as slipping in winter, by organising the work site in a due manner.
Otherwise the weather conditions do not set any restrictions on the operation. When
starting the machine in severe frost, allow it to idle at about 1/4 of the maximum speed
for about 5 to 10 minutes.
Only operate the machine in an adequately lit space.
It is recommended that a suitable stand be purchased or made that enables the trees
to be processed where the logs are ready at the level of the in-feed deck. Hence,
unnecessary lifting may be avoided and the work can proceed much faster. We
recommend using either the Palax Mega log-deck or the Palax Log log-stand.
The most suitable temperature range for operation is approximately - 20 to +30
degrees Centigrade. Otherwise, the weather conditions do not set any restrictions on
the operation.
Make sure that no other people, especially children, are present inside the operating
range.
Never use the machine indoors, owing to the risk of dust generation or the danger of
exhaust gases.
1.11
Terms of warranty
The warranty period runs for 12 months from the date of purchase.
The warranty covers
Parts which have been damaged during normal operation of the machine due to any
defects in material or workmanship.
The reasonable repair cost as set forth in the agreement between the buyer and the
manufacturer.
A new part is delivered as a replacement for the defective one.
The warranty does not cover
Defects due to normal wear, faulty operation or negligent maintenance.
The crosscut saw-blade, V-belts and oils.
Defects in the machine due to any modifications which the buyer has made or ordered
from a third party and which have affected the machine in such a way that it can no