Palax C750 Ergo, Инструкция по эксплуатации

Страница: 10 / 34

10
Palax C750 Translation 1-2018
Never remove any safety-related devices from the machine.
The width of the machine equipped with the 4,3-m conveyor is about 2.83 m. This
means that, depending on the size of the tractor, the transport width of the conveyor
may extend outside the rear wheel on the right-hand side.
The operator
Every person operating the machine, must thoroughly study the entire user manual.
Always use eye guards and hearing protectors.
Always wear protective shoes.
Always wear work gloves.
Do not wear loosely-fitting clothing.
Before use
Always carry out the required preparations on both the machine and the conveyor
before starting the operation.
Make sure that all other people stay outside the operating range.
Only use a fault-free PTO shaft and attach the chain for the shaft-guard. The
permissible revolutions range of the PTO shaft is 450-540 r.p.m.
Only operate the machine on a sufficiently firm and level surface.
Only operate the machine in an adequately lit space.
Keep the tractor-powered machine connected to the three-point linkage. Also ensure
that sufficient space is provided for the PTO shaft and its guard.
Always check that all the covers are intact and properly fastened.
Always check that the crosscut saw-bar is intact.
Always ensure that the electric conductors are intact.
Always check that all the controls are operational.
Always check the oil level and make sure that the hydraulic hoses and components are
free of damage.
Before starting the work, make sure that the machine is firmly in position.
During operation
Carelessness during the cut-off operation constitutes a major hazard!
During the cut-off operation, make sure that the tree at the cutting point always leans
against the support roller of the crosscut deck and the infeed roller: danger of rolling
over!
Exercise particular caution when cutting knotty or crooked logs, because, as a result of
faulty cutting, the log might roll over or twist the saw-bar with enough force to break it.
Keep the working space clean and clear of foreign objects.
Always stop the machine and disconnect the power supply cable or the power take-off
shaft before servicing.
Only cut one log at a time.
Danger! Stay away from moving parts.
1.8 Noise emission and vibration
Equivalent continuous A-weighted sound-pressure level at the workstation is 88.5 dB (A)
and the sound power level is 108.5 dB (A). The vibration emission values do not exceed
2.5 m/s2.