Painless Performance Products 10106, Руководство по установке

Страница: 9 / 45

5.1 Familiarize yourself with the harness by locating each of the harness sections in the
following list. (Whenever a particular harness section is referred to in these instructions it
is shown in “all caps”: ENGINE SECTION A) Note that, according to the particular harness
you have purchased, some of these sections may not be present, and some are not
labeled.
ACCESSORY SECTION SWITCHES
ACCESSORY SECTION B+
BACKUP SECTION (one wire)
BRAKE SWITCH SECTION
DIMMER SWITCH SECTION
EMERGENCY BRAKE SECTION (one wire)
ENGINE SECTION
ENGINE SECTION (Single, 10 gauge red wire)
ENGINE SECTION A
HEADLIGHT SECTION A
HEADLIGHT SECTION B
IGNITION SWITCH SECTION
RADIO SECTION (one wire)
TAIL SECTION
TURN SIGNAL SECTION
Note: For complete information concerning the individual circuits and wires
that make up the harness SECTIONS, see Section 12.0. Also see the
CAUTION notice at the beginning of Section 6.0.
5.2 The Painless wire harness is designed for the fuse block to be mounted on the driver’s
side, under the dash on early models and to use the factory firewall bulkhead opening in
late models.
5.3 Decide which of the following circuits you will be using in your system and where the
harness groups or wires will be routed:
Routing Location and Placement
Emergency Flashers ______________________________________________
Horn ______________________________________________
Dome Lights ______________________________________________
Lights ______________________________________________
Cigarette Lighter ______________________________________________
Wipers ______________________________________________
Air Conditioner ______________________________________________
Electric Cooling Fan ______________________________________________
Coil ______________________________________________
Turn Signals ______________________________________________
Radio Ign. Switched B+ ______________________________________________
Gauges ______________________________________________
Accessories ______________________________________________
Backup Lights ______________________________________________
Cruise Control ______________________________________________
5.4 Where will the following harness groups be routed?
Headlights ______________________________________________
Engine ______________________________________________
Dash ______________________________________________
Tail Lights ______________________________________________
4