SECTION 4
OPERATION
73
4.6.3.3 UPC STATUS (cont’d)
TRANSFORMER RATIO:
Output Transformer Ratio: To change this see section 3.4.1
CONFIGURE TRANSFORMER RATIO.
Pas=
1
,
2
, or
3
. This is the number of power amplifiers in the Power
Source. To change this value, refer to para. 3.4.4 CONFIGURE
MISCELLANEOUS SETTINGS.
AMPS:VOLTS RATIO
This sets the ratio of current to voltage for the UPC metering signals.
To change this see para 3.4.2 CONFIGURE AMPS TO VOLTS
RATIO.
PRI/SEC:
PRI
mary or
SEC
ondary. This is the current transformer location
relative to an output transformer. To change this value, refer to para
3.4.4 CONFIGURE MISCELLANEOUS SETTINGS.
EOS=
CR/LF, LF or CR
. The factory default Serial port End-Of-String
character(s) value is CR/LF.
4.6.3.4 POWER SOURCE STATUS
POWER SOURCE STATUS indicates the state of internal control signals between the UPC and the
Power Source circuits. See para 2.3.4 OUTPUT CONTROL and para 2.3.5 INPUT CONTROL for a
description of these signals. This display is only used for technical diagnostics.
From any METER display (V/I, AMPS or POWER), press the
fn
key to enter SETUP MODE.
From the SETUP display, press
3
to enter GENERAL SETUP.
From the GENERAL SETUP display, press
4
to enter POWER SOURCE STATUS.
POWER SOURCE STATUS:
3PH 1PH CONNECTOR XFMR
CMD FALSE FALSE FALSE FALSE
CONF FALSE FALSE FALSE FALSE
CMD
:
Are Command signals sent from the UPC to the Power Source.
CONF
:
Are Confirmation signals sent from the Power Source to the UPC.
Pressing the
+/-
key toggles the Connector CMD signal state.
Содержание UPC-12
