SECTION 4
OPERATION
60
4.6 SETUP
MODE
SETUP MODE is used to:
•
Copy and Delete Programs
•
Copy, Edit, and Create Waveforms
•
Set Min. and Max. Voltage Limits
•
Set Min. and Max. Frequency Limits
•
Engage and Disengage CSC (Continuous Self Calibration)
•
Set the Metering Sense Point – Internal or External
•
Set Slew rates
•
Set Transition Time
•
Set Transformer Ratio
•
Enable keyboard lockout
•
Set initial power on output voltage
•
Monitor UPC and Power Source status
•
View Firmware Version
•
Enable Calibration Mode for Metering
•
Adjust LCD View Angle and Backlight Intensity
•
Set GPIB Device Address or Serial Interface Parameters
•
Erase
Memory
•
Set Amps-to-Volts Current Metering Ratio
•
Define Current Transformer Location
•
Set Output Range - for power sources that support it
•
Display the Number of Power Source Amplifiers
•
Synthesize Waveforms from Harmonic values (Option)
•
Calibrate Programmable output impedance (Option)
•
Enable and Set Programmable Output Impedance (Option)
From any meter display, press the
fn
key to enter SETUP MODE.
SETUP: PRESS 1 FOR PROGRAM SETUP
2 FOR WAVEFORM SETUP
3 FOR GENERAL SETUP
4 FOR CALIBRATION MENU.
4.6.1 PROGRAM SETUP
PROGRAM SETUP is used to copy and delete programs and erase memory.
From any METER display (V/I, AMPS or POWER), press the
fn
key to enter SETUP MODE.
From the SETUP display, press
1
to enter PROGRAM SETUP.
PROGRAM SETUP: PRESS
1 TO COPY A PROGRAM,
2 TO DELETE A PROGRAM,
3 TO ERASE ALL MEMORY AND RESET CPU.
Содержание UPC-12
