Oval FLOWPET-EG LS4976-4 0A Series, Инструкция по эксплуатации

Страница: 59 / 72

S-178-10(E）
(5) The procedure to enter a parameter
Switch operations sequence in "Parameter Setup Mode" comes in three ways (numerical setup, units
setup, and decimal point setup) that follow:
①
Numerical setup parameters (F, H, Pu, At, A, and Pon)
The blinking digit in the parameter setup mode is the place of interest.
MODE …
Each time the switch is turned ON, the blinking place moves one place to the left.
RESET …
Each time the switch is turned ON, the figure in the blinking place increases by one. Or exponential
sign toggles ("E"
←→
"-").
→
Following the parameter setup, hold the "MODE" switch depressed for 2 seconds (the new setting is
established and the screen returns to the review mode).
L
Example: Parameter “Un”(units of registration)
②
Units-of-registration parameter (Un)
In the parameter setup mode, the indicated unit of registration flickers.
MODE
…
Not used in the setup process
RESET …
Each time the switch is turned ON, the screen scrolls through available units of registration.
→
When the desired measurement unit appears, hold "MODE" depressed for 2 seconds (the setting is
established and the screen goes back to the review mode).
Each time the switch is turned ON, the screen scrolls through available units of
registration (g
→
kg
→
t
→
L
→
kL
→
m
3
→
L (normal)
→
kL (normal)
→
m
3
(normal)
→
None).
L
Example: Parameter
“
F
”
(meter factor)
Exponential sign (E: 10
+n
, − : 10
-n
)
(The screen above reads F=1. × 10
0
L.）
Digit of interest (blinking)
Turning MODE“ON”moves the blinking digit one place to the left.
Turning RESET“ON”
increases the figure by one (“0”→“1”).
Units of registration (flickers)
NOTE: This function merely changes
the units of registration indicated at the
bottom of LCD. It by no means affects
the process of flow calculation.