SJ-20162405182123-002|2016-05-24 (R2.0)
Speedport Entry 2i Maintenance Management Guide
6-12
Parameter
Description
Authentication
Type
It must be the same as that set on the peer server. Normally, it is
set to
Auto
.
l
Auto
: The device automatically selects an authentication type
based on the authentication types that the peer server supports.
l
PAP
: Only the PAP type is used.
l
CHAP
: Only the CHAP type is used.
Retry Times
Number of retries.
13. Click
Diagnosis
. The system starts simulation. The result is displayed in the bottom
box.
– End of Steps –
l Please don't refresh this page while diagnosing, otherwise the diagnosis result
may be displayed incorrectly.
l If a new diagnosis is triggered when the current diagnosis is still running, the device
will only respond to the new diagnosis, and the current diagnostic result will not be
saved.
6.9.
Check the ARP Table
The relevant information of ARP table is shown as below.
Steps
1.
On the main page of the Speedport Entry 2i, select
Management > ARP Table
to
go to the
ARP Table
page, as shown in
Figure 6-13 ARP Table Page
2. Click
Refresh
button to refresh information.
– End of Steps –
Caution!
