SJ-20162405182123-002|2016-05-24 (R2.0)
Configure the Internet
3-29
Parameter
Description
Connect Type
The connection type that is used to connect the outside,
including TCP, UDP, and TCP AND UDP.
The default service type is TCP.
WAN Port Range
Specify the port range of the device protocol that the triggering
port maps, that is, the layer-4 port number of the packets.
Once the device accesses the triggering port, the service
between the start port and end port will be enabled.
The WAN Start Port and WAN End Port must be specified and
meet the following conditions.
l The end port number is larger than the start port number.
l The difference between the end port number and the start
port number is less than nine.
Timeout
The time when no traffic occurs.
3. Click
Apply
button to apply the changes.
– End of Steps –
3.6.
Configure the Parental Controls
The section describes how to configure Parental Controls.
Steps
1. On the main page of the Speedport Entry 2i, select
Internet > Parental Controls
to
go to the
Parental Controls
page, as shown in
Figure 3-22 Parental Controls
