SECTION 3 - BASE COMPONENTS
31215825
3-13
Spindle Disassembly
Figure 3-13. Spindle Disassembly
1.
Place Spindle Sub-Assembly on bench with Planet Gears
(G9) facing up.
NOTE:
Do not damage or scratch the seal surface of the Spindle
(G1) during disassembly.
2.
Remove three Output Planet Shafts (G10).
NOTE:
These Planet Shafts are held in with a press fit. Use the
tapped hole in the end of the pin in conjunction with a
slide hammer or similar tool to remove them.
3.
Remove the Output Planet Gear (G9), Thrust Washer
(G25), and Tanged Washer (G32) out each of gear “win
-
dow” of the Spindle (G1).
NOTE:
The Output Planet Gears (G9) are very similar in size to
the Input Planet Gears (5), tag or label the Planet Gears
to avoid confusion.
4.
Press out Bushing (G26) from the bore of each Planet
Gear (G9). Bushings cannot be reused when removed
5.
Remove the Main Bearing (G14) from the outside diame
-
ter of the Spindle (G1).
NOTE:
This bearing is held in with a press fit. You will need to pry
against the Spindle (1) to remove it. A new bearing should
be used when the unit is reassembled.
6.
Flip over the Spindle (G1).
7.
Press out the Motor Shaft Seal (G17) from the center
bore. The seal cannot be reused when removed
8.
Remove the shaft Ball Bearing (G15) from the center
bore.
Go to
Discount-Equipment.com
to
order your
parts
