SECTION 6 - TROUBLESHOOTING
31215825
6-33
Code 35 - P2-Auxiliary #1 - Tie Down
Check For These Obvious Conditions First:
• Pressure on the Platform Foot-switch during machine power up.
NOTE:
In the procedures below, if you check continuity between pin 6 and 16 it should show open circuit, when the platform gates are closed
and nothing is on the foot-switch. When you step on the foot switch with the gates closed, you should see a closed circuit.
Code 38 - Battery Voltage Low - Warning Level 2 - Two (2) LED/LCDs lit
To maximize battery life, it is recommended that the factory supplied batteries be charged continuously for a minimum of 4 hours or
until 8 bars are lit on the ground station LCD Display before operating the machine. When drained to Warning Level 2, batteries must
be charged until 8 bars are lit on the ground station LCD display to clear the fault code. Failure to do so, will result in a fault code 39.
Code 39 - Battery Voltage Low - Warning Level 3 - One (1) LED/LCDs lit
To maximize battery life, it is recommended that the factory supplied batteries be charged continuously for a minimum of 4 hours or
until 8 bars are lit on the ground station LCD Display before operating the machine. When drained to Warning Level 1, batteries must
be charged until 8 bars are lit on the ground station LCD display to clear the fault code.
Table 6-35. Code 35 - P2-Auxiliary #1 - Tie Down
STEP
ACTION
SPEC
YES
NO
1.
At the Ground Control Module, P2 connector, check the voltage
across pins-16 (orange/red 49-5) and 6 (black 12) is reading within
specification?
0 - 2V DC
Go to Step 2
Replace Ground
Control Module
2.
Remove the P2 connector from the Ground Station Module; check
continuity of the individual wires in the platform harness.
(P2 to plat
-
form junction box),
—
Go to Step 3
Repair or
Replace Platform
Harness
3.
Check continuity of gate switches and foot switch circuit.
(Switches
are wired in series; doors shut and foot switch depressed, circuit will be
closed)
Consult Factory
Replace Compo
-
nent or Repair
Wires
Go to
Discount-Equipment.com
to
order your
parts
