Operator Manual
Cha
pt
er
:
Di
sp
la
y
20
Work session
Press the START key on the initial menu (STAND-BY) to begin the work session. An hourglass indicates to wait because verifications and
preparation for the start of the session are in progress.
Once this phase has been completed, the welder is ready and the following screen appears:
The Power, Time, Freq, Spot, Wave form, Post-Gas, + and - keys can be selected from the Touch-screen and the Joy-stick, which is found inside
the welding chamber. When selected, the Power, Time, Freq, Spot, Wave form, Post-Gas keys become orange.
The settings recovery/save key and for Switch-off of the Laser can only be selected via Touch-screen.
The dimension of the Spot can only be modified using the lever positioned inside, on the left side of the welding chamber.
Welding parameters:
1.
Power: The power of the LASER pulse is set from a minimum of 0.5 kW to a maximum of 4 kW with steps of 0.1 kW.
2.
Time: The duration of the LASER Pulse goes from a minimum of 0.5 ms to a maximum of 15 ms with steps of 0.1 ms up to 10 ms and
of 1 ms from 10 ms to 15 ms.
3.
Freq: The frequency of the LASER pulse goes from a minimum of 0 Hz (Single shot every time pedal is pressed) to a maximum of 15
Hz.
4.
Waveform: the following LASER pulse waveforms can be selected:
5.
Post-Gas: The post-gas duration goes from a minimum of 0 seconds (No post-gas) to a maximum of 9 seconds with steps of 3
seconds.
6.
Spot: The following welding spot dimensions can be set: 0.3 mm, 0.4 mm, 0.6 mm, 0.7 mm, 0.9 mm, 1.00 mm, 1.2 mm, 1.3 mm, 1.5
mm. The welding spot box is green when the current value is the same as the value memorised in the program selected, and flashes
when this value does not coincide. This function is useful to memorise spot values in the programs and recall them successively.
Saving the Welding Parameters
Once identified, it is possible to save all the welding parameters that are most suitable for a certain type of machining in a customised settings
program.
Press the
key to access the setting programs Recovery/Saving menu. Up to 16 programs can be saved inside the machine (ROM) and
16 in the USB pendrive; the support is selected via the ”Media” key
Saving the parameters
Once the most suitable parameters for a certain type of machining have been identified (e.g. to weld silver), save the settings as follows:
Press the
key, select the location of the memory in which saving is to be performed, e.g.
, press the
key to
save the settings in this location. Press the
key to access the keyboard that allows the name to be changed.
Enter the name using the keyboard and press the OK key to confirm, or the
key to exit without saving.
Press the
key and the Program1 text will be replaced with Silver.
1
2
3
6
4
5
